Is there a good way of cleaning the engine bay without removing to much?i know to use the pressure washer and not get anything electrical too wet but is there anything that will help get rid of the oil and some alloy oxadision?
elbow grease mate...
Halfrauds do some.
I\'ve used the Bike cleaner from halfrauds. Seemed to do a good job with a washing up soft brush and low pressure flushing water.
Shaun
gunk engine degreaser perhaps?
Ive heard Gunk is good, you could steam clean it, but im not sure how much it would mess up the electricals
I ususlly get a rag with some petrol on it to get the worst off. You can use things like colour restorer cause those will cut through the grease and oil. Also used gunk with reasonable success :)
Gunk is kinda the same as parafin but with a nicer smell! Get a five litre can for a few quid, a bag of rags to wipe it on/off with and you\'ll be able to clean your engine bay forever and not run out!
i use Gizer when i can be bothered - and an old toothbrush :D
Yup i\'m with Grinder, i use jizer in a compressor parts washer gun tho much quicker lol, and it\'s water soluble so you can wash it off too :)
cool thanks for the replys,i dont like doing work so i\'ll try the gunk from halfrads and pressure washer.
Try WD40.
Just mind rubber seals, it\'ll eat them!
Did whole of my engine bay, smells funky too :D
Did you know that WD-40 stands for Water Displacement, the 40th formula design by NASA?
i was told wd 40 was really good for rubber?
I took my engine bay out and cleaned it with petrol washed it and then painted it with hammerite smooooove!! looks the fookin nutz mate
Quote from: DR SCHNITZEL;517688I took my engine bay out and cleaned it with petrol washed it and then painted it with hammerite smooooove!! looks the fookin nutz mate
Fancy doing mine?? :D
Adam
Quote from: DR SCHNITZEL;517688i was told wd 40 was really good for rubber?
I took my engine bay out and cleaned it with petrol washed it and then painted it with hammerite smooooove!! looks the fookin nutz mate
Noooo, very bad! WD does, indeed muller rubber with prolonged exposure. That\'s why you should never use it to clean suspension sliders and that, even though it seems ideal. It swells the seals up, they tear and then p!ss oil out all over your brakes. Highly undesirable!
Dear Dr Scnitzel,
If I took my engine bay out, I probably wouldnt have much of a car left? lol
Oven cleaner for metal parts. Brings them up nice.
(will not be held resposible if applied to painted parts for too long as it will make a mess but short periods are fine!)
POR15 Marine clean.
It\'s brilliant. End of :)