Guys,
Is this the oil level sensor in the sump? I noticed the connector some while back, and the oil level light hasnt been on to indicate a problem. In the picture you can see Im holding the connector, and above the subframe you can see the sensor in the sump.
(http://www.fevvahz.co.uk/pic/rx7/Sensor_Disconnected.JPG)
The light came on intermittently some while back but it stopped doing it. I regularly check oil levels and its never run low. The oil level lights now on, and I managed to trace where this cable is connected too, and I think its the oil level sensor.
As far as I remember its always been disconnected. So how is it only coming on intermitantly, and on constantly now? Also - where abouts in the loom is the opposite connector for this one so I can get it hooked up again?
there is one in the sump. plug it back in, if it is intermittent then maybe change.
i have a sump on its own with one in hence why i know :)
Quote from: m4drx;512152there is one in the sump. plug it back in, if it is intermittent then maybe change. i have a sump on its own with one in hence why i know :)
I know theres one in the sump. Its in the picture. Im holding the connector attached to it. Im sure if I plug it into something then it will change, my point is - into what?