Hi im wondering how hard it is to cut a fibreglass bumper? I have heard it can be done with a metal angle grinder. Would this be ok. i dont want to crack/damage the rest of the bumper just shave about 2-3 cm off the bottom of it.
Got a quote of 600 for it, which is more than i paid to fit, paint, prep and remould the bumper in the first place. i think the garage doing it is a bit of a joke.
Anyone got any ideas?
Shaving a bit off the bottom shouldn`t be a problem, just make sure the bumper is secure and held down tight. £600? what a bunch of c**ts!:3Confused:spank
Be very carefull cutting fiberglass wear a good mask. The fiberglass dust particles are hook shaped when viewed under a microscope. Get them in your lungs and your stuck with them for good. As for cutting a small angle grinder and cutting blade will do the job or a pneumatic body saw with a fine blade.
Kevin
mate dont know how thick this bumper is but there is nothing difficult with it, just make sure you cut it straight.
use grinder cutter with a metal cutting plate, and make sure you hold it straightafter that sand the sharp edges down with a sand paper ..and make sure you cover your eyes..
i\'ve done it milion times before and never chipped/cracked anything...
Piece of cake - dremmel