OK so it didn\'t make it in time for the weekend, and that has cost me a pint (Blitzboy - I\'ll get you your Magners tomorrow!)
But a lot has happened at old hillbilly motorsport over the past week and it could have been finished if the oil cooler pipes had arrived but here are some progress pics (you will note the lacy of IC or rad - they are on the floor in a nice V-mount position ready to be fitted
that looks a fairly large turbo there :D
moderatly large ;)
It\'s a GT4088
Why has it taken sooooooooo long. Are you getting it done on the cheap??
Me no understandy???
Still no HOVIS though!
After all this work I bet you can\'t wait to get it back. I\'ve not driven mine for over a week and its doing my head in!
Mark, I salute you - that looks the dogs danglies :yes
Are you sure there is enough housings there :Giggle
Looking like it will be a great deal of fun :D
Shaun
Quote from: adereedStill no HOVIS though!
:D
also, have you got enough rotor housings there?
ooohhhh pics
i would be a little worried personally if my car was in a garage and it was in that state though :(
looking really good, almost reminds me of mine. Where did you buy your oil line to the turbo from as i need one.
the progress being they have dragged it from the back of the barn to a slot near the door. Should be a matter of months now if all they have to do is fit the I/C and rad! :)
(now let em prove me wrong)
Quote from: grinderooohhhh pics
i would be a little worried personally if my car was in a garage and it was in that state though :(
That\'s just the hillbilly way ;) considering how much stuff is in the barn it is very carefully placed around the cars so no damage is sustained!
QuoteWhy has it taken sooooooooo long. Are you getting it done on the cheap??
Me no understandy???
Erm a couple of reasons,
1) I have changed my plans twice since the car went in
2) Chris Impey keeps blowing up his drag car! :spank
Not actually getting it done cheap but RX Motors are very reasonable priced compared to others...
Quote from: antnicukthe progress being they have dragged it from the back of the barn to a slot near the door. Should be a matter of months now if all they have to do is fit the I/C and rad! :)
(now let em prove me wrong)
The I/C and Rad are in a V-mount just not fitted yet, in fact they are sitting on the floor just out of shot!
Woo hoo! :Thumbsup!
Looking interesting Mark - you must be getting really excited now! It\'s been a long time since I\'ve seen this car in the flesh RSII I think???
Can\'t wait to see it and hear it :)
:wave
i counted 29 rotor housing its like wheres wally for mazda owners :)
29! you need to look harder :), (unless the scrap man has been?) there used to be about 15 piles stacked 25 + high! it is an aladins cave in there though
Quote from: danny_m94i counted 29 rotor housing its like wheres wally for mazda owners :)
I found 38 (in the 2nd pic) and that\'s not including the ones in his engine or the engine to the side - just the free ones !
http://www.walkerbooks.co.uk/Downloads/Wheres-Wally-Activity-Kit
:Giggle