Mazda Rotary Club

General => General Technical => Anything Engine/Performance/Tuning related => Topic started by: RemarkLima on February 18, 2008, 11:00:27 AM

Title: Knightsports FCD Type D and a cut wire.
Post by: RemarkLima on February 18, 2008, 11:00:27 AM
Hey all,

Meant to post over the weekend, buy while swapping the ECU over I found the car had a Knighsports FCD Type D, dunno if this is any good or not but assume it\'s just stop Fuel cut from too much boost... Not that my boost is above normal but may have had an overboost switch after all.

Also there\'s a cut wire, now I think it\'s the speed wire to the ECU, it had bullet terminals on it so designed to be reattached if needed, but the old ECU said my speedo sensor was out and the PFC Commander reads 0 KMPH.

But I think this would be the wayto get round the 112mph speed limiter, as mine never had this ;)