Print Page - fitted the new rear diffuser

Title: fitted the new rear diffuser
Post by: batman on February 16, 2008, 02:51:34 PM

my god this was hard to fit tabs not in the right place had to move everything and cut out most of the exhaust bit as it was catching and would have melted dam the 90mm pipe
but all in all :Thumbs-up

(http://i2.photobucket.com/albums/y10/ascaudio/rextray1.jpg)
(http://i2.photobucket.com/albums/y10/ascaudio/rextray2.jpg)
(http://i2.photobucket.com/albums/y10/ascaudio/rextray3.jpg)
(http://i2.photobucket.com/albums/y10/ascaudio/rextray4.jpg)
(http://i2.photobucket.com/albums/y10/ascaudio/rextray5.jpg)

Title: fitted the new rear diffuser
Post by: Laeeq on February 16, 2008, 03:00:34 PM

Looks good but i would take the back no plate off as there is a bracket behind from which you can attach brackets and pull it up so it lines up behind the no plate. You must have some brackets that you use for stereos. It will look much better fit plus will be more secure oh and don\'t worry about the plastic bit under the bumper; with a bit of push it will move up in place easily...

Title: fitted the new rear diffuser
Post by: Laeeq on February 16, 2008, 03:01:22 PM

oh and love the rims and your gt wing...looks tops:Thumbs-up

Title: fitted the new rear diffuser
Post by: batman on February 16, 2008, 03:16:21 PM

thanks laeeq was from your buddy in london said he new you

Title: fitted the new rear diffuser
Post by: Hayward North on February 16, 2008, 03:50:33 PM

thought the stock back lip needed to be removed to fit this ?
I may be wrong.

Mazda Rotary Club

General => General Technical => Anything Engine/Performance/Tuning related => Topic started by: batman on February 16, 2008, 02:51:34 PM