Mazda Rotary Club

General => General Technical => Topic started by: Hound Dog on February 17, 2004, 08:46:55 AM

Title: how too ??
Post by: Hound Dog on February 17, 2004, 08:46:55 AM
anyone done a how too on changing gearbox and diff oil ?
Title: how too ??
Post by: J4P RX on February 17, 2004, 08:50:20 AM
Nope.

Is that a volunteer? :D

Cheers
Lee
Title: how too ??
Post by: Hound Dog on February 17, 2004, 09:17:44 AM
i may have a go have to learn some time , any recommenations for what oil to put in gear box and diff ?
Title: how too ??
Post by: Fish on February 17, 2004, 10:17:28 AM
Not got a how to, but if I get time at work later I\'ll write one up.

As for the oil I would use Redline Heavy Shockproof oil.

Fish
Title: how too ??
Post by: Squealy on February 18, 2004, 02:53:19 AM
Agree with Fish.  Redline is always a good bet.

To change oil is fairly similar to most cars. Take her for a gentle run to warm the oil.  (Heat thins oil. It ill run through better.) Undo bung on bottom. (buy new washer for this as old one will be failrly manky due to position. About 20p from Mazda).  Filling is a mor awkward affair as filler is on the top (right hand side from what I remember).  You will be needing a sqeezy pottle and a tube to do this.  A washing up bottle (well cleaned out and a piece of silicon tubing would do (try fish tank air tubing perhaps). Unfortunately cant remember how much oil is needed. Quite a bit though.  Half fills box apparently.  As with most things it is an easy concept but an awkward (and messy) reality.

I recommend getting a garage to do it.  Easier that way.

Neil