Hi all,
I am looking at buying the above has any one got any pics of it fitted to their car so i can see what it looks like. Thanks in advance.
Cheers Garith.
Pic of my intercooler, hope that helps.
Thanks Dazsir,
Does the girder type thing behind the bumper need removing and will that affect the fitting of the bumper. Also does it affect the airflow to the rad?
Cheers Garith.
Yes you will need to either cut it back or remove it.
The Greddy coolers are pretty good at allowing air past. You may notice water temps up a couple of C.
Fish
Now then, the bumper reinforcement bar needs to be cut down. The instructions show you how.
Thanks will read through in depth later. Just had a quick read and it seems alot of work. Is it worth the work what will be the difference from stock i/c and will i need my apexi mapping?
The difference over stock is MASSIVE. You\'ll get better charge temps, which will reflect in better power.
Fish
Thanks Fish,
I have an apexi on not been mapped the only after market piece so far is apexi induction and greddy elbow and hard pipes. Will i need mapping done if i fit this or will the standard map (after learning mode) work ok?
Cheers Garith.
Yes would be worth getting it checked. You\'re close enough to ReWorx, Dragon, Tim and Carl.
Fish