As title says
Is 55mm close enough to work on the flywheel nut?
54mm bud for the flywheel, iv heard its a bugger to get off unless you have a impact wrench? if youv got a compressor, a impact wrench is the best tool you`ll ever own lol.. the time n hassle mines saved me is amazing :evillaugh
Quote from: MartinyAs title says
Is 55mm close enough to work on the flywheel nut?
The answer has got to be yes mate.
I\'ve not tried it but once you get bigger than 30mm, 1 or 2mm oversize works fine.
Many, many people use a 55mm socket for the flywheel nut.
thanks guys, its about £12 cheaper for a 55 than a 54.
Make sure you\'ve got something to go even longer than a 60cm breaker as you\'ll need it. It needs huge amounts of torque to tighten it again as well so a scaffold pole is good.
Where in surrey are you mate, if your near guild bish still has my 1m breaker bar.
A
Just out of interest how much does the nut cost to replace, I ended up just chiseling the darn thing off after it refusing to come off with a socket. I only got my hands on a sheet socket.
Shaun
Although putting it back on is an issue :Giggle
Shaun
Quote from: shaunwilJust out of interest how much does the nut cost to replace, I ended up just chiseling the darn thing off after it refusing to come off with a socket. I only got my hands on a sheet socket.
Shaun
thats exactly what i did... and a hammer and a chisel to get it back on and i havent had any issues.
if it is a single hex one Martin I bet you will be just fine. It\'s not a tiny 10mm A/F nut after all :)
and my flywheel nut came off just fine by hand, I made a proper steel bar to stop the flywheel from turning and used a 1" drive breaker bar thats about 2feet long came off with some mild heaving.
the front pulley nut was worse but gave in after a few minutes with my electric impact wrench (240V one ... brilliant tool and really handy)
Martin I may be able to pop round with my \'Snap-on\' impact gun, I\'d have to stay while you do it though incase I need it.
PM me I\'m in woking Mon +Tues till late if any help
Paul..
Thanks Paul- But do you have the socket - I have ordered but it might take a few days to arrive, maybe Thu/Fri?
I used a 55mm socket which I found in my local tool shop, and a 110 volt impact wrench with 240 volt transformer which I hired from speedy hire for £30 over the weekend.
I made a flywheel stopper just like the mazda SST which I believe one2watch had, and may have gone to somebody else as well. Can\'t remember where it is now, as he may have sent it back, but I\'ll happily lend it out to anyone that needs it if I can find the thing. It fits in a small padded bag so it\'s easy and fairly cheap to mail around.
Sorry mate bigest socket Ive got in the van are 45mm
in the impact type
Paul..
The flywheel is not the hard one to get off, the 19mm Crank pulley is the PITA to get off (its liquid locked)
Paul, its arrived already ! If you read this, what are the chances for tonight?
ok mate mines at home, but found a spare on another van just charging it up right now to make sure its got some go in it.
Only just seen this, but have been on call for the storms in the last hours.
PM me ASAP with your phone no and I be over.