I\'ve at last got round to taking a photo of my \'bay. Taken a while to do, but I have one now!
Spec is:
Apexi BNR33 fuel pump
550 primaries
1200 secondaries
Street ported engine
Radtec v-mount
Garret GT35R turbo
Turbosmart 48mm external wastegate
RX Motors 3" downpipe
Greddy Profec B Spec II boost controller
(http://i78.photobucket.com/albums/j116/nikp75/022.jpg)
(http://i78.photobucket.com/albums/j116/nikp75/021.jpg)
Looking good Nik but wheres my turbos :p
P.S - Wow that battery is a tight fit!!
Tubbies are in sheffield, as i thought they\'d be easy for you to pick up then :)
nice nik plenium looks good powder coated,, hows my tap doing??
Looking good!
You need to put some plate around the gaps between the intercooler and the radiator. Remember air will take the easiest route. I put an airflow meter on the intercooler, and formed a matrix. The airflow was less than a quater through the front section of the intercooler.
After plating the sides, the airflow became even right across the rad, even inducing a bit of back pressure!
If you need any help just ask :D