Mazda Rotary Club

General => General Technical => Topic started by: bally on May 22, 2007, 07:14:07 PM

Title: what sort of bhp you guys running
Post by: bally on May 22, 2007, 07:14:07 PM
hi guys just as the title says im running a single turbo t3/t4 hybrid on a 95 fd i was chatting with jonofd3 and i seem to be low on power compared to some singles or even twins
spec below
t3/t4 turbonetics turbo
apexi fc and commander
k&n cone filter
hks v mount
uprated rad
extra injectors (550)
255 walbro pump
ally ast tank
she has been mapped at wgt just seems low in power thats all any ideas on what i can do next or advice much appreciated :3gears-lh
Title: what sort of bhp you guys running
Post by: John Yorke on May 22, 2007, 07:40:05 PM
Ist and formost you need to spec the turbo - what size hot side,what  compressor?
How many miles on the engine what type of port, too many variables to hazzard a power figure, what fuel pressure ..........loads
Title: what sort of bhp you guys running
Post by: Warthog on May 22, 2007, 08:02:21 PM
As per my sig, thats what I\'m running.:wave
Title: what sort of bhp you guys running
Post by: pete sparrow on May 22, 2007, 08:05:02 PM
Did you have a compression test done at WGT at the same time??
Title: what sort of bhp you guys running
Post by: bobert on May 22, 2007, 08:50:53 PM
Quote from: ballyhi guys just as the title says im running a single turbo t3/t4 hybrid on a 95 fd i was chatting with jonofd3 and i seem to be low on power compared to some singles or even twins
spec below
t3/t4 turbonetics turbo
apexi fc and commander
k&n cone filter
hks v mount
uprated rad
extra injectors (550)
255 walbro pump
ally ast tank
she has been mapped at wgt just seems low in power thats all any ideas on what i can do next or advice much appreciated :3gears-lh

It all depends on what porting you have and what boost you are running?

My spec.

Masterpower t-70 turbo
Street ported 13B
Uim porting
850cc primary inj
1600cc seconadry inj
Profec B boost controller
Large fmic
Power fc
Warlbro 255 fuel pump
469 fwhp @ 1.2 bar

Further mods that have been carried out but not yet mapped:

HKS twin power
Water injection
Extended street port

Hopping for 500bhp if I take the boost up a bit:Giggle
Title: what sort of bhp you guys running
Post by: bally on May 22, 2007, 09:58:05 PM
my boost was only 0.9 bar after map compression was v good accordin to pip as regards my turbo no dam markings on it what so ever
Title: what sort of bhp you guys running
Post by: pete sparrow on May 22, 2007, 10:00:37 PM
Quote from: ballymy boost was only 0.9 bar after map compression was v good accordin to pip as regards my turbo no dam markings on it what so ever
What bhp are you hitting then? You failed to mention it in your first post.
Title: what sort of bhp you guys running
Post by: bally on May 23, 2007, 12:53:49 AM
280 atw via dynapack at wgt
Title: what sort of bhp you guys running
Post by: John Yorke on May 23, 2007, 06:00:28 PM
Sounds like you may have a T3 turbo which wont flow much if any more than the twins, most likely stock ports, I\'d assume you have some work todo, 280ish ATH is about 310 -320 fly not great but dependant on spool should be fun and not likely to go pop to soon.
Title: what sort of bhp you guys running
Post by: MikeLMR on May 23, 2007, 06:03:52 PM
probably about 90hp at the wheels on a good day