Text only | Text with Images

Mazda Rotary Club

General => General Technical => Topic started by: michaelb on May 17, 2007, 05:50:43 PM

Title: intake tepm with induction kit, any suggestions?
Post by: michaelb on May 17, 2007, 05:50:43 PM
Hi All

I know this subject has been talked about many times before her but here it is:

I have recently purchased from a member on here an HKS Racing Induction Kit.  

I do not want to fit it and create higher intake temp since the air to the filters will be drawn form under the bonnet not form the nose of the car.  I drive the car in London and very often I am stuck in traffic.

So here it is, can any one suggest someone / vendor to create for my 96 jap FD with standard IC special vents or even better can any one make me those vents / tunnels to take the air to the filters from the nose.

I will be more then happy to pay for the work or pick up the staff..

Regards,
Micha
Title: intake tepm with induction kit, any suggestions?
Post by: DC-TYPER on May 17, 2007, 06:28:57 PM
go to a dry washing machine repair shop and ask for the tubing off a tumble dryer  :)
Title: intake tepm with induction kit, any suggestions?
Post by: michaelb on May 17, 2007, 06:32:56 PM
Quote from: DC-TYPERgo to a dry washing machine repair shop and ask for the tubing off a tumble dryer  :)

OK

Have you got a picture of this phenomenal design?  I am not sure if you are joking or serious though..

Regards,
Michaelb
Title: intake tepm with induction kit, any suggestions?
Post by: ro284 on May 17, 2007, 06:37:54 PM
You can get 3 inch or 4inch stainless flexi pipe from some boiler supplies,
Bob
Title: intake tepm with induction kit, any suggestions?
Post by: michaelb on May 20, 2007, 02:15:26 PM
Quote from: ro284You can get 3 inch or 4inch stainless flexi pipe from some boiler supplies,
Bob

Thanks for that

Is this what you have had done under your bonnet?  If so do you have any photos?

Regards,
Michaelb
Text only | Text with Images