Just wondering if anyone has an Aquamist system installed, i have just perchased one and it looks like im missing a part, there is what looks like a filter before the inlet of the pump, i need to know what the name of this bit so i can order a replacement, any ideas ?
think it may be "Inline Water Filter" possible part number 806 257, if somebody could confirm this if they have a aquamist
ta :)
That is correct part No 806-257, should look like this...
(http://i17.photobucket.com/albums/b51/kevnokia/004.jpg)
Much appreciated m8, that is the piece that is missing, gonna order it now.
Would be much appreciated if i could pick ya brains if thats your setup in the picture.
Just a few Questions i have that kinda get conflicting results with.
1, Water tank : duz it need to be air tight to make a pressurised container.
2, Duz the lowest level of the water tank need to be higher than the water pump.
3, Where did you take your injector feed from ?
Yes I do have a version of 2D installed.
Quote1, Water tank : duz it need to be air tight to make a pressurised container.
2, Duz the lowest level of the water tank need to be higher than the water pump.
3, Where did you take your injector feed from ?
1, No tank
must not be air tight.
2, The tank is best above level of the pump, or you can fit a one way valve in line between tank and pump.
3, I have microtech ECU, but red wire from FIA2 control box goes to a 12v ignition source. The green wire is spiced into the negative side between injector and ECU. Mark (BlitzBoy) may help on this point.
Helps a lot thnx.
On another note, i sore a post a while back with differnt sizes of engine bay bottles on, just wondering if anyone know the site that sels em.