Print Page - fitting GReddy turbo timer

Title: fitting GReddy turbo timer
Post by: Revsport on April 30, 2007, 04:23:44 PM

jsut got my GReddy ful auto timer and i have the rx7 harness, does anyone have or know of any online instructions??

japanese isnt my forte as much as id like it to be!! :Tongue1

Title: fitting GReddy turbo timer
Post by: dazsir on May 06, 2007, 09:41:37 PM

its very straight-forward to fit if you have the harness....

The harness goes in between a big connector, round the steering column.

Title: fitting GReddy turbo timer
Post by: shaggy on August 14, 2007, 12:44:05 PM

I have this turbo timer too and have the harness. That bit is straight forward and will operate the timer. From what i can gather the brown wire goes to the handbrake. and the purple wire goes to the ecu at a specific pin for the speed signal, i know which pin it is in my 1999 car bt pre 96 were different. God knows what the grey wire is for my japanese isn\'t that good yet. Anybody else have any ideas? It has a female push connector.

Title: fitting GReddy turbo timer
Post by: Grizzly on August 14, 2007, 07:50:24 PM

http://www.fd3s.net/turbo_timer_install.html

http://www.greddy.com/tech/

Title: fitting GReddy turbo timer
Post by: shaggy on August 15, 2007, 10:38:23 AM

Ok thanks for that. All fitted now an works fine. Anybody know if i can make my Cobra alarm work with it properly?

Mazda Rotary Club

General => General Technical => Anything Engine/Performance/Tuning related => Topic started by: Revsport on April 30, 2007, 04:23:44 PM