hey gents!!
i am just half way through fitting a greddy pulley kit as i have removed the air pump,
i have just noticed that when i fitted the water pump pulley that it is fouling against the coolant hose and clip so wont turn???
has anybody else had this problem and what can i do about it??
any help would be great cheers lee
Try turning the clip around a bit. The hose should not foul the pulley. Try rotating the hose a little untill it clears
i have tied that but it still seems VERY close
is this still ok?
Mines very close too but has never rubbed so you should be ok...
ok cheers lads i will try tommoz morning when its not dark and let ya know what mess i make!! lol
lee
SORTED!!!
all i had to do was replace the original clamp with a jubilee clip and all is good!
was getting ready to pull out the grinder too!!! lol
cheers lads
lee