Might sound a bit dopey, but what size hole does a 52mm gauge need in the area its going to be fitted into?
I\'m just scoping out a hole saw to put some holes in a bit of a project and could do with knowing whether it\'s a 52mm that\'s needed or different. Most of the hole saw sets seem to have a 51mm bit, which would be good if a 52mm gauge could fit through the hole.
Cheers for any help :god
Alex
What are you cutting ? If it is plastic dash trim 51 mm will be sweet because you can wedge the guage in and it will not twist or move once you seat it. I always drill 1mm less when installing a guage in something plyable..
It\'s plastic, so that\'s the perfect answer. Nice one!
Cheers for that
Alex
Drill it out to 50mm then sand out to the correct size for a nice tight fit.
Fish