Mazda Rotary Club

General => General Technical => Topic started by: Jim_rx7 on March 15, 2007, 02:13:00 AM

Title: Quick question....
Post by: Jim_rx7 on March 15, 2007, 02:13:00 AM
I was looking for somewhere to put my front jap sized number plate. Was going to put it either far left or right of my c-west bumper where the small openings are.

But looked behind the mesh to see some sort of cooler each side of the car.

What are these?? Oil coolers?

pic of bumper so you know what I\'m on about....

(http://i58.photobucket.com/albums/g279/weebockle/small4.jpg)
Title: Quick question....
Post by: FD3SNuttah on March 15, 2007, 02:22:51 AM
yes they are oil coolers.
Title: Quick question....
Post by: Jim_rx7 on March 15, 2007, 02:26:47 AM
so not advisable to cover them up!! Damn... thought the jap sized plate would look good over one side of the bumper too!
Title: Quick question....
Post by: gsb876 on March 15, 2007, 02:34:54 AM
Quote from: Jim_rx7so not advisable to cover them up!! Damn... thought the jap sized plate would look good over one side of the bumper too!

Dont cover the oil coolers up mate for obvious reasons, if you are struggling to get a plate on either get a sticky plate or one that flattens while driving to get max air flow into the intercooler :Thumbs-up

The C-west front is brill for allowing loads of air feed :Party
Title: Quick question....
Post by: Jim_rx7 on March 15, 2007, 02:41:16 AM
where can you get sticker number plates? Also are normal plates that flatten legal?? Anywhere sell them or the brackets that are required for them?

cheers bud!! :)
Title: Quick question....
Post by: strange_days_uk on March 15, 2007, 02:41:47 AM
jono FD3 on here makes them, PM him