Print Page - What do I need to remove

Title: What do I need to remove
Post by: dazsir on February 20, 2007, 08:03:24 AM

Hi my 7 has a decat, FMIC, sports exhaust, Greedy Airinx twin filters, I have an Apexi PFC on its way. Is there anything I need to remove in preperation for this?
My car farts and crackles a lot it is rather amusing but I have heard that you should not run the air, pump with a decat?

How do go about removing the Air pump - before you all grizle I have looked but cannot find the relevant info! What else do I take off?

ANy walkthroughs of removal?

Thanks

Title: What do I need to remove
Post by: andysmee on February 20, 2007, 08:15:24 AM

Have a look here http://www.mazdarotaryclub.com/forums/showthread.php?t=29915&highlight=bac+valv (http://www.mazdarotaryclub.com/forums/showthread.php?t=29915&highlight=bac+valv) and the linked thread in that post

Edit: Sorry, that was 2nd generation so may not be of use to you...

Edit Edit: http://www.fd3s.net/air_pump.html (http://www.fd3s.net/air_pump.html)

P.S. You\'re right, there does seem to be a lack of a "how to" on this one even though loads of people have done it. Can you take some pics when you do it?

Title: What do I need to remove
Post by: peterwolds on February 20, 2007, 09:37:38 AM

Darren still got my air pump on,no problems running with it

Title: What do I need to remove
Post by: m4drx on February 20, 2007, 10:09:44 AM

Quote from: dazsirHi my 7 has a decat, FMIC, sports exhaust, Greedy Airinx twin filters, I have an Apexi PFC on its way. Is there anything I need to remove in preperation for this?
My car farts and crackles a lot it is rather amusing but I have heard that you should not run the air, pump with a decat?

How do go about removing the Air pump - before you all grizle I have looked but cannot find the relevant info! What else do I take off?

ANy walkthroughs of removal?

Thanks

has the car been ok running with those mods?

Title: What do I need to remove
Post by: dazsir on February 20, 2007, 11:10:56 AM

define what you man by running well? Yes it seems ok, idles at 1100rpm and will only boost to about 0.5 bar, think it miht go above but I dont watch the gauge as I speed along!

Title: What do I need to remove
Post by: m4drx on February 20, 2007, 11:18:05 AM

0.5 bar is too low which indicates you have a problem somewhere fella, my car wouldnt boost above 0.5 a little while ago due to a few things.

i meant more along the lines of running lean. most of the guys will say you should never put a larger intercooler or decat a car with a stock ecu? i have bought a larger SMIC and planning to get a decat but i cant put them on till i get an aftermarket ecu because of the threat of the engine going pop. the advice i have always got was either cat back or air filters or perhaps both any more and you must get an aftermarket ecu such as an apexi.

Title: What do I need to remove
Post by: dazsir on February 20, 2007, 12:31:45 PM

Thanks for that, will get one pronto and have it away to WGT.

Title: What do I need to remove
Post by: Jono FD3 on February 20, 2007, 04:10:23 PM

M4drx is correct...... but the only time you will run lean is when you start to open her out (when the turbos come online) Also I would recomend a boost controler as you will get boost spikes due to the extra flow of the exhaust, which will make it imposible to get a safe map on the power fc as it wont be a constant pressure in to the engine!!

Jono

Title: What do I need to remove
Post by: dazsir on February 20, 2007, 05:27:59 PM

fitted a HKS EVC 5 boost contoller which is keeping the boost under control..

Mazda Rotary Club

General => General Technical => Topic started by: dazsir on February 20, 2007, 08:03:24 AM