Print Page - Modifying a primary rail for 850\'s

Title: Modifying a primary rail for 850\'s
Post by: allstaruk on December 28, 2006, 12:20:56 PM

Hi guys

Next question, he he I bet your getting fed up with me now, I have one standard primary rail, and one set of 850 injectors here, now I wish to put the injectors int the primary rail, now I am aware that you need to mill the primary rail down to get them to fit but is this somthing I can do myself with a very flat sander or will I have to get an engineering company to do it.

Basically all advice would be well recived.

Alan

Title: Modifying a primary rail for 850\'s
Post by: interloper393 on December 28, 2006, 12:35:07 PM

hmm id get an engineer to do it bud, dosnt cost much and it a be perfect then :)

Title: Modifying a primary rail for 850\'s
Post by: allstaruk on December 28, 2006, 01:28:14 PM

Ok cool, its 2mm that needs to be milled of isn\'t it?

A

Title: Modifying a primary rail for 850\'s
Post by: interloper393 on December 28, 2006, 01:38:41 PM

not to sure bud, if your handy with the tools giv it a go.. im all for diy :)

Mazda Rotary Club

General => General Technical => Topic started by: allstaruk on December 28, 2006, 12:20:56 PM