found this fitting guide
http://www.clubrx.org/media/pfc/PowerFC_FAQ.pdf page 10
but do the 4 wires (well my car only seems to have 2 of the said wires)need to be cut on a jap spec car?
cheers
mike
you only need to cut wires on a US spec car.
no need to do anything on jap spec
ok cool, just wanted to check
Blitz, i enquired about this the other day and Steve kindly replied,
QuoteQuote:
Originally Posted by ro284
Steve, what wires need to be cut? i just got mine today, PFC FD3S4 not even looked at instructions yet, bit worried about cutting wires!any links to info on this please?
cheers Bob
http://www.clubrx.org/media/pfc/PowerFC_FAQ.pdf
There ya go.
Read it carfully and follow the installation procedure to the letter and your car will run fantastic.
When you cut the few wires just snip them about 2 inch from the block connector on the back of the wireing harness then if you make a mistake you can always resolder them.
The wires are for immisions in the US i belive.
If you have any probs then just drop me a msg or post here.
I am a bit confused now, should we cut wires or not? please advise,
Cheers Bob
he mentions in that post the wires are for the US versions, the PFC does not work properly on a US spec car until the wires are cut.
No wires need to be cut on Jap spec cars
DONT CUT ANY WIRES lol
DO NOT CUT WIRES ON A JAP CAR
as Mark says
Thanks guys i got the message,
cheers Bob
Hmm are you guys sure about this ?
Sory ignore me i didnt read the post correctly
Quote from: steve garbuttHmm are you guys sure about this ?
Hi Steve, no I\'m not sure, that\'s why I put it in caps !!
lol
I think we need to start a new WTF thread !! :cheers :rollin