I was toying with the idear of going single so ordered this a few weeks back, the hotsides 0.58 tho, can this be machined wider or would i need to buy another housing? also how would this run on a fd as it, came of a fc.. id have a streetport done once engine is striped, but if i increase the hotside, would this increase the max power output?
Any guide to stripping one of these as i want to send it off to get polished.
thanks.
(http://i49.photobucket.com/albums/f279/ooomoo/Picture001-5.jpg)
(http://i49.photobucket.com/albums/f279/ooomoo/Picture002-5.jpg)
(http://i49.photobucket.com/albums/f279/ooomoo/Picture003-5.jpg)
(http://i49.photobucket.com/albums/f279/ooomoo/Picture004-7.jpg)
the a/r is way too small for a Rotary. You would need to buy a new exhaust housing for it if you can
Definately need a new rear housing...as you would need a vband connection of some sort on that one anyway....it would endup costing you as much as the housing that i have...also you get all the connection bits for the downpipe with mine.