Mine arrived this mornin , so when i got home from work thought id stick it in,fitted it as per instructions, after about 8 minutes at idle the revs started to fluctuate between 1600rpm and 700 rpm? switched a/c on as i thought this may add a load and help even out the idle, but did not work.
so... thought i would try driveing it, drove fine apart from the \'heat\' light on the dash kept flashing and the commander was showing alot of det even at low revs/ slightly accelerating, an i no it shouldnt be knocking or detting as its just been rebuilt!
any help would be very much appreciated
cheers
mike
the apexi need to self learn do not drive before idle sorted..re set it and start car and leave to idle for 10mins then gradually add electrical load..heated window air con etc waiting each tinme for idle to stabilize
how do i reset it?
cheers
Try doing a search on the Form Mike, its most usefull and will stop you needing to ask questions that have already been asked before.
Apexi instruction is on this sticky thread for everyone to read
http://www.mazdarotaryclub.com/forums/showthread.php?t=5579
there is a link in there for the apexi instruction manual