had car out yesterday and all was fine until i stopped to re-fuel
jumped back in car drove back to work and got as very strng smell of petrol coming in airvent,
got to work opened bonnet and the smell and eye stingyness got stronger.
so i thin i have a leak in engine bay some where any ideas if theres a pipe that leaks easy or am i having to rip everything out to check it??
It could be the main ones, more than likely its the lines that are UNDER the rats nest :(
Don\'t drive it until you get it sorted!!
it may well be your Pulsation damper on your Uper fuel rail, they tend to drop that much fuel out when they Play up.
And if you do need to move it have a Fire Extinguisher handy, Better to be safe than Sorry.
ssssssshhhhhhhhhhhhh dont say that ive only just done rats nest lol
anyone got a diagram of where the fuel lines runs??
and so the fun begins lol
Tbh if you think you have a Fuel leak your Best of taking the Upper mainfold back off and follow the pipes from the Fuel filter (between the Gear box and the NS inner wing) all the way round untill you come back to the Return pipe at the inner wing again.
My money is on the Pulsation damper on the Bulkhead end of the lower fuel rail.
But before you start, just check the charcoal canister breater from the Tank is still conected and in good nick. (BTW thats the third Fuel line you will see with the Filter and Return line just follow it and it will take you to the canister)
Hers some thing to get you on the right track.
http://www.rx7club.com/showthread.php?t=595408&page=1&pp=15&highlight=Pulsation+damper
BTW, on the pic below the Damper is the Green thing in the Center (looks like a UFO ;))
one word
******** lol
so hows replaced their fpd`s???
and whats involved
read the write ups but still not 100% clear
right managed to start the dreaded fpd,managed to get a look at where it was but from what i can see it doesnt seem that damp or wet,
dont want to go ripping everything out to find that it wasnt that at fault.
cant see anyother damp bits at all but i did get a fuel smell in bay and coming in heater blower.
notice the little things starting to go in car now lol
see this part is it ment o be right through or blocked off??
mines seems solid.
Quote from: mikeyhright managed to start the dreaded fpd,managed to get a look at where it was but from what i can see it doesnt seem that damp or wet,
dont want to go ripping everything out to find that it wasnt that at fault.
cant see anyother damp bits at all but i did get a fuel smell in bay and coming in heater blower.
notice the little things starting to go in car now lol
Thing is your Not looking for wet patches, Fuel Evaporates. You are looking for Water marks or very clean bits.
Does it run ok? You have tightened the Upper inlet up havent you... :)
If its that strong can you see any Dripping under the car when it was running?
Right, open the diagnostics terminal and ground out the fuel pump, turn the ignition to on and you will here fuel being pushed through the system. Fingers crossed it will reveal your leak :)
aaa too late for that i just got stuck into it and its all in pieces now lol.
so might just replace the fpd i take it there`s 2 of them one on each rail??
and anyone know of any british suppliers?
also needing 2 injector seals for bottom rail.
had a good look about and everything seems ok.
i only got the smell when i put in v power lol maybe car doesnt like it.
is this the 2 injectors??
the bit with 2 holes in the middle as its the seal for in there i need.
thanks
the two holes sat next to eachother in the centre plate are where your primary injectors sit, there should be a rubber ring/seal in each one, normally has a bit of white paint on it.
any ideas to where ill get everything i need as my local dealer is bloody useless.
or am i better going to the states
looking for....
pulsation damper
more vilon hose for rats nest(ones i couldnt get to but now can
would the fuel line i use in garage do the bits or do i need high temp stuff?
the 2 seals for the primary injector housing
thanks
Quotemore vilon hose for rats nest,
Hi Mikey, expect it\'s a spelling mistake mate, but just to make sure you need to be looking for VITON
Good stuff,
Bob
yeah same thing too early in the morning for me lol
right built the fuel pipes back up again replaced the fuel pipes and did the short the fuel pump.
everything seeem ok no leakss or smell?mmmmmmmmmmmmmmmmmmm
also managed to break a solinoid the one right at the end towards the bulkhead so im needing one of them
who does viton or silicone hose got some before but cant rememer who from.
so looks like ill need to take the chance and build it back up again.
hate doing jobs twice lol
o well you live and learn
Rx Motors do Viton Vac hose.
thats the one lol
manage to get some from pip and the solinoid so hopefully get her back on road for weekend