Forgive me for asking what many of you might think is a stupid question, but, what is the point in turning sequential turbos into non sequential turbos? Obviously there is a reason for this but i just aint got the faintist what it is!
Basically to remove some of the complication that the sequential setup entails. Do a bit of searching around and you\'ll find that the seq setup can cause a few problems, and be hard to diagnose when it does go wrong. There is a lot of info on the subject in previous posts on the forum.
Ian is right. There really is no benefit, unless you have problems with the system/s that switch from 1 turbo to both, (and if you dont want to diagnose or repair that)
It also provides a small insight into what its like to go Single.
Bulla