Mazda Rotary Club

Cars by Model Type => 3rd generation RX-7's => Topic started by: MillSpeed on October 02, 2006, 07:17:26 PM

Title: How are the \'efini\' and \'RX-7\' badges held on?
Post by: MillSpeed on October 02, 2006, 07:17:26 PM
As per the title really, I was hoping to pull the \'superman\' efini and RX-7 badges off the back of my car, but I was wondering....are they just stuck on or are there any locating pegs going through the rear bumper? I don\'t want to pull them off only to find a nice collection of holes. Only reason I ask is when I got the car, some nice chap had removed whatever badge sits underneath the RX-7 badge leaving some sticky stuff a pair of holes where the badge should have been.

Cheers all.
Title: How are the \'efini\' and \'RX-7\' badges held on?
Post by: Grizzly on October 02, 2006, 07:21:51 PM
From memory they have pegs and clips holding them on.

Sorry, Yes you will find a collection of Holes.

The only ones that arn\'t peg and clip are the "RX7 Enfini" badga on the rear (if its an Import) or "Mazda Rx7" if its a UK car.
Title: How are the \'efini\' and \'RX-7\' badges held on?
Post by: MillSpeed on October 02, 2006, 07:24:36 PM
Guttog. Oh well, they can stay where they are then! Cheers Griz
Title: How are the \'efini\' and \'RX-7\' badges held on?
Post by: robedwards99 on October 02, 2006, 07:32:07 PM
Just 3 (I think) small holes on my back bumper. Hardly notices on a black car.
Title: How are the \'efini\' and \'RX-7\' badges held on?
Post by: tailz on October 02, 2006, 10:22:50 PM
Yes, the same here. 3 small holes - mine is black & I had forgotten they were there until reading this!!