for sale......£220 or offers.
Carb is set up for a 13b, has the upper manifold (will fit both 6 and 4 port lowers) and i can probably find you a filter and some linkage for a little extra.
THE BEST conversion...apparently.
steve
Is This still for sale?
Does anyone know if it will fit the 12A engine as well?
Welcome to MRC :Giggle
Take a look on ebay.com and ebay Australia - theres normally a few manifolds going on there :)
Also, a lot of the rotary specialists will have some parts hanging around you could use :)
Is yours the Herald on RR?
:wave
wow bring back an old thread from the dead!!! Top thread resurrection!
Hi brett, Hello all.
Yes mine is the one on RR. thanks for the advice will begin the search
BlitzBoy - Sorry, google link brought me to the post really should of checked the date but worth a shot.
lol no worries, Dubber91 always has bits lying around I\'m sure he will have something for you
Cheers mate, I hope someone has as I\'m running out of time as usual. (Friends wedding deadline (11th April)) lol!! nothing like a rush
Try speaking to Carl Hayward of Hayward rotary - got a feeling he has one for sale?
Cheers brett. (Highlight, copy, google, paste)
hey man, try travellin bob on here or on e x i l e. hes got some bits he wont want a lot for IIRC
yep thats me....am up and moving to oz in a few onths time...actually maybe sooner now that i stop and think about it!! so have a fair bit of stuff for sale.
give us a shout on here or a pm etc on ....., either or is all good with me.
cheers, michael.
doh.......... just found a side draft delorto 48 under the bed...n..seriously, if you are still looking then give us a shout, £120 and it is yours, michael.
Cheers for the offer there mate, I\'ve rersorted to running a 460 Holley for the time being but out of intrest is that just the 48 or do you have the manifold as well?
Hi Micheal,
I would be interested in your carb please.
Can you give me a call to sort out details please?
Regards
Carl
just seen this, i also have the racing beat part of the manifold, and it bolts to a fc lower inlet manifold.
cheers, michael.
Hi Michael, I realise I\'m digging posts from the past again but have you still got this 48 carb and mainfold? ? ? If so would like to sway it from your hands...
no sorry mate, sold it to carl hayward. might be worth asking mark, the guy who has the bright yellow fb rx7 as he has a 45 side draft i think with manifolds etc.
cheers, michael.
no worries, thanks.
that would be me then, yes have a 45dcoe with manifold to fit a 13b 4port motor up for grabs
Mark
Cool, but will (sorry about this, I\'m still new to rotarys) the 13B mainfold fit to the 12A engine? or will I need a different manifold?? I assume the 45dcoe is strong enough to run the rotary but the power gain is less that a 48dcoe??
yes you will need another manifold, depends on where you want the carb to sit but there are a couple of options (over the top as mine was or straight out from the engine) if you are running a stock 12a i dont think you will see a massive differance over the 48
Is this till up for offers mate?
how much £ were you looking for?