Changed oil and filter today in preperation for trax, first track outing in the rex, absolutely cannot wait. :Thumbsup! :Thumbsup!
Refilled the oil, start hes up to pump it around and recheck the level....hang on a minute that seems a bit louder than normal...:confused: :eek:
Turbo to downpipe gasket is half gone !! 2 nuts loose, one tight, one missing altogether !! :spank :spank Need to watch that a bit better dont I !! :spank
So now I\'ve gotta get her up on stands outside my house, pull the downpipe (fiddley and not fun) get a pattern off the gasket, email it to turbo shops and try and get a new one sent to me in time to get it all back together again in time for Trax. :eek: :D :Typing
Hope the weather is looking kind over te next days or I\'m getting V wet doing this.... :bandit
Worse still, I\'ll have my own car lift installed in a couple of months as my friendly garage has just closed and given me one of their ramps (nice people !!) if this had happenned 2 months later, no problems !! :reallymad
I cant even take it to them to get it sorted as they\'ve just closed up and I\'ve no time anyway.
I must have been driving it around like that for weeks now, just shows how silly loud the car is that I didnt hear any difference untill I ran her with thte hood up ! Darent take her on track like that though...no way.
Just thought I\'d get it off my chest !
P.S. If anyone has any gaskets for a T04S kicking around please feel free to shout up !!
Ouch...hope it doesnt cause too much grief & its fixed soon...how handy is that to get some ramps installed at home!
ahh so you dont have a v-band fitting then.
Hmmm cant you make up a bit of metal for a gasket and use a bit of exhaust putty on either side to seal?
Quote from: RixioOuch...hope it doesnt cause too much grief & its fixed soon...how handy is that to get some ramps installed at home!
Getting the lift installed at work not at home (I dont even have a garage :()
But yeah will be awesome once sorted :cheers
I\'ve so many plans over the winter it\'s silly !!
Quote from: BlitzBoyahh so you dont have a v-band fitting then.
Hmmm cant you make up a bit of metal for a gasket and use a bit of exhaust putty on either side to seal?
V-Band wasn\'t invented when they built my turbo :rollin
I\'ve been advised by Carl Haywood not to use putty as if any gets in the turbo it\'s goodnight vienna.
Should be doable just about, just what terrible timing !!
yeah make up a metal gasket then you should be good to go
Quote from: BlitzBoyyeah make up a metal gasket then you should be good to go
Will use that as a last resort, hoping to get the real deal sorted in time, if not I\'ll try the metal route but I have doubts that a steel gasket will be malleable enough to do the job, and aluminium will melt !! I have other material available but dont know which will suit the job... ??? ??? ???
Copper ? Brass ?