How do you fit a turbo timer - does it have to be done professionally or is it a diy job.
Also When you have a cat 1 alarm can you lock and set the alarm before the timer stops without it going off or do you have to tweek the alarm.
i would like this info aswell
i had a Clifford concept 500 (cat 1) alarm fitted and the guys that did it said my turbo timer would make the alarm go off but since then i have heard from another dealer that they where talking out of there preverbial , so i want to refit my turbo timer but i dont know how , it doesnt look to hard with 2 plugs and 2 wires should be easy , just dont know where the 2 wires go
it is a diy job if you want to want around for the timer to finish timing before you set the alarm, or if you run a clifford300 or above, i think you can hook the timer to the alarm and it should arm after the timer stops, but you will have to pay someone to get this done. I personally just wait till the timer to finish, cheaper and most of the time you will only be waiting a minute or so.
Do you know where the 2 wires go
are they just power
which two wire, what timer have you got?
it is the standed one you see on all the pictures from japan
Ultra 4753
and looking at it there are 4 wires that are not on a plug
is there 3 thicker ones and one thiner one
From the main unit there are 7 wires 4 thick ones going to a plug and 3 thiner going off to a small plug and there is a black wire that comes out of the cable loom further away from the unit that is quite thin
i would take a pic but the camera batterys are flat , i will post it when the battery is charged