Mazda Rotary Club

General => General Technical => Topic started by: shaunwil on May 05, 2006, 05:44:05 PM

Title: Fitting a HKS twin spark
Post by: shaunwil on May 05, 2006, 05:44:05 PM
Im considering getting a hks twin spark amplifier as the next item towards going single. Has anbody fit one in the past, how hard is it to fit ?

Cheers

Shaun
Title: Fitting a HKS twin spark
Post by: sdminus on May 05, 2006, 05:46:24 PM
Shaun i have the xs power amp which is a lot cheaper.

I have no probs with it at all and it will provide full voltage to the ignitor with no alternator ( for racing )

You have to adjust the ign dwell times after fitting tho. Not sure on the hks unit tho

Scott
Title: Fitting a HKS twin spark
Post by: Gerry M on May 05, 2006, 06:27:35 PM
THe HKS twin spark is very easy to fit & you can get a specific harness for it. like I did just a matter of  disconnecting a plug, plugging the 2 halves of the harness in & thats it basically, just have to to mouth the amp where you want it & route the cables
Title: Fitting a HKS twin spark
Post by: shaunwil on May 05, 2006, 06:30:32 PM
Cheers guys, so i need to add the cost of a harness into the mix ! Did it come with full instructions ?

Cheers

Shaun
Title: Fitting a HKS twin spark
Post by: Gerry M on May 05, 2006, 06:32:48 PM
you dont need the harness as you can splice the wires in I just ised one because it was easier. Came with full instructions in english but with pictoral. If you do a search on here you should find out where it plugs in as I asked the question a while ago. Loom cost me £30 part number for it was 4399-SZ001
Title: Fitting a HKS twin spark
Post by: Rixio on May 08, 2006, 01:30:13 AM
What is a "HKS TS Amp" and what does it do?