Just came across this...
link (http://www.rx7club.com/showthread.php?t=537008)
Thats some impressive power figure, especially the torque :2eek
Using a SMIC as well.
same turbo that i\'m running, similar set up to mine but his is streetport and mine is bridgeport, and i have FMIC.
I wanna run 25psi for RS3, should be interesting :flamed
Hope you got a monster fuel setup for 25psi Dre, I maxed out a Skyline gtr pump at 18psi
Really?!?! I have a Nippon Denso pump from RX7 store and same injector setup as you. What fuel pressure was that at?
I think around 60psi.
Dre have you had yours dynoed yet?
I want to run more boost so I have ordered a twin pump setup and swirl pot, hopefully get in for RSIII
no it hasn\'t been dynoed yet. Had a few problems with it. Now waiting for ignition amp and W/I which should be on the car by the end of next week, then hopefully mapping weekend and see what happens with the fueling!
Ahh its an American dyno, still good numbers, would be inclined to reduce the AW by at least 10%, Dre : you must be like a cat on a hot tin roof :D Know what it is like waiting for the \'final\' bit [ie: tuning]
BB is right without BIG fueling you will struggle to run +1.3bar, what have you done to the drive train to cope with that sort of power?
i would say 20% is more realistic be fair. especially if your comparing to a DD dyno
25 psi, thats gotta be 1.7 bar........ thats a lot of boost.... i\'m assuming race fuel was used