can some tell me how you remove these
or gain access to them my driver 1 is loose and need to tighten
i did remove door car and looked inside the door seem inpossible to get too
any advide would be good
chris :rolleyes:
the mirrors wil fold in either direction, they may seem stiff but will move, if you fold them the bolts/screws are under the mirror, no need to remove any panels what so ever
Cheers M8 Thats Great Help Thought If I Force It May Snap
Chris, let us know how you get on, I\'ve got the same issue!
Yes I had the same problem too and removed the inner door panel to no effect. I\'ll try again now. :)
spray a load of wd40 or something inm there, they get seezed up from water getting in there. took me ages to get mine off at the week end
right all sorted now!!
it easy all you have to do is push the mirror in or out to gain access to the screws and tighten if they are still loose undo the screws you have just tightened and you be able to remove the mirror itself the mirror will not come off complety as electric wire will still be attached let it hang when you have done this you will have access to the base plate tightened this and then refit mirror and tightened screws again and now you will have tight fitted mirrors
chris
good luck :wave :wave
Quote from: chris@yocoall you have to do is push the mirror in or out to gain access to the screws
sorry, i`m being dumb, when you say push the mirror in or out, do you mean the glass or the whole unit?
thanks
The whole unit will pivit 90 degrees ish inboard (excluding the collor where the bolts are) - like some card do for parking on narrow streets.
HTH Ricco
ok thanks mate, didn`t want to just give it a pull and break it, i can be a bit too heavy/num handed sometimes!:p
cheers