Hi all,
How/where do you get wires from the engine bay into the car?
I\'ve got two wires from Defi sensors that need to go through but can\'t figure any easy way to do it. How has anyone else done this?
Any help much appreciated!
Paul.
theres a rubber gromet/bung down to the passenger side footwell. as u look in from your bonnet its down between the brake set up and inlet, i used a cooking utensel to start the hole off then fed mine through, just becarefull of the other wires
Gud luck
yes that is where i put mine through a bit fiddily but it can be done
Any chance of pics? I can only see one rubber gromit in the passenger footwell that\'s below where the brake stuff comes through but can\'t see it in the engine bay?
I can\'t go from the footwell to engine, has to be the other way.
I can see a huge great gromity thing in the engine bay but can\'t get to it as it\'s high up in the footwell behind a load of stuff?
Cheers!
HEY DUDE
have u tryd the driver side as there is a hole there n thats wer i feed\'d my power cable....!
There is a grommet on the inside of the drivers wing between the turret and the bulkhead, with wires in, if you push a coat hanger carefully through there you can take the wing repeater indicator out and fish the wire through into the cavity there, but i had to drill through near fuse box in drivers footwell, carefully!
i have since done it differently though, if my pic works you can see the dotted tube from temp sensor and boost going through bulkhead, this comes into the car just above the clutch pedal mounting bracket, i drilled through just to the right of the brake servo 25mill down from the lip, i found this the best position as hoses are long enough to reach my speaker guage pod!
good luck
Bob
Cheers!! I\'ll give it a go next weekend when I\'m home while it\'s light again :) See if I can break more drill bits ;)
The main wiring loom comes through the bulkhead below the windscreen wiper motor. the rubber gromet that it goes through is a bit awkward but thats a good place, also if you have removed the aircon then the holes where the pipes go through are very good for cables pipes or whatever else you feel like poking through...those pipes go through the bulkhead just below the oil filter if i remember rightly...
just watever you do be carefull!!!! lol
dont want to be seeing a "wiring diagram" post from you next week
Haha :) Cheers all. Yeah I was hoping to avoid drilling but the connectors are square, maybe 10mm x 3mm on one of the leads.
I\'ve got to drill holes in the doors anyways, I\'m sure it\'ll be fun ;)