I recently replaced my rear dampers but am still getting rumbling / slight knocking from the rear of the car so I\'m guessing its the bushes on the way out.
How many are there on the FD3 to replace ?
Is it a fairly easy job ? Any specialist tools required ?
Cheers for any help input.
Rich :)
Got same problem with mine too....anyone??? Where can we get these rear bushes costing less then an arm and leg...lol.. :3Confused
Also had the same problem, and on mine it was the the two rear top pillow bushes that were picked up at m.o.t. time, not a failure! but they were noisy, i got mine done at RX motors, but costly, i watched how they were done, and it didn\'t look too difficult, need a good vice, hammer, and make up some drifts with sockets, any more i will do myself, just a bit of guidance via a sticky on here would help,
Bob