Print Page - changing coil packs

Title: changing coil packs
Post by: james01uk on November 29, 2005, 11:41:46 AM

hi
i am going to remove my plenum tonight and replace my ****ty coil packs can anyone tell me how to do this the quickest and easiest way?

thanks

james

Title: changing coil packs
Post by: Fish on November 29, 2005, 12:09:33 PM

Well your most of the way there, removing the plunum is the only way to go. Other than that just do one at a time.

Fish

Title: yeah
Post by: james01uk on November 29, 2005, 02:15:58 PM

yeah i figured that would be the easiest way to do it.

any idea if there are any pics etc on this to make it easier

Title: changing coil packs
Post by: Fish on November 29, 2005, 03:07:41 PM

Dont know of any pics, but from digging about in the darkest depths of my little mind you will need to un-do a couple of nuts that are a sod to keep hold of. Make sure you dont drop them.

Fish

Title: from where
Post by: james01uk on November 29, 2005, 03:23:51 PM

where from? top middle or bopttom?

Title: changing coil packs
Post by: Fish on November 29, 2005, 03:36:03 PM

Side and in between. Try and have one of those stick magnets to hand.

Fish

Title: are there many nuts
Post by: james01uk on November 29, 2005, 04:02:29 PM

ok i will try lol

how many buts are thee to remove?

Title: changing coil packs
Post by: shaunwil on November 29, 2005, 08:20:36 PM

I used this when i took mine off for powdercoating, just make sure you plumb everything back ! I half took min apart again after pulling the boost sensor pipe out of the plenum, oops

http://www.robrobinette.com/manifold.htm

Shaun

Mazda Rotary Club

General => General Technical => Topic started by: james01uk on November 29, 2005, 11:41:46 AM