i need to know how to wire my after market tacho, all the normal lighting and power wires im fine with, but where do i connect the green sensing wire????
someone must have done it?
ta
nick
Nick,you need to connect it to the Tacho output signal wire or the ignition coil (-) signal wire on your main wiring harness. check out //www.iluvmyrx7.com for manual download to locate these wires :)
Hope that helps
Quote from: thebanditNick,you need to connect it to the Tacho output signal wire or the ignition coil (-) signal wire on your main wiring harness. check out //www.iluvmyrx7.com for manual download to locate these wires :)
Hope that helps
havent i got three coils??
cheers
N
nick, best thing would be too look on //www.iluvmyrx7.com to find which wire on the block that connects into your ecu is the rpm signal wire then take a feed off it :)
if you look at this nick it will give you the wire locations your after in the wiring section (scroll down)
http://www.apexi-usa.com/pdfInstallation/14.pdf (http://www.apexi-usa.com/pdfInstallation/14.pdf)
you are the man!!!!!
cool cheers mate
n
No problem buddy :)