Print Page - 2 Single Dins ?????

Title: 2 Single Dins ?????
Post by: gdhaggis on August 31, 2003, 11:04:52 PM

Hi Guys,

After your advice again.

I want to put 2 single Din units in my 1994 RX7. At the moment I only have a huge gap and need some help.

Is there a cage to purchase ? If no, what do I do ? How do I get the 2 units to sit on top of each other ?

All I can see is a bracket at the back of the gap, which has 2 holes in where the rubber fire thingy would normally sit.

Help and advice would be appreciated from here in Swansea.

Thanks very much.

Gareth.

Title: 2 Single Dins ?????
Post by: <--rYaN--> on September 01, 2003, 04:00:12 PM

You can buy single din cages from places like Halfords etc, i have a single din unit at the moment and i have this black plastic front which slots into the empty din slot, they\'re pretty generic sizing as its not rx7 specific, so they arent that hard to get ahold of!

Title: 2 Single Dins ?????
Post by: mr_tim on September 01, 2003, 04:34:39 PM

are there any 1 din cubby hole type things that i could replace the blanking plate with? The thing I miss in the RX is little places to put my stuff.

But then when you do come from a car with cup holders all over the place...;)

Title: 2 Single Dins ?????
Post by: J4P RX on September 01, 2003, 06:22:01 PM

I have a cubby hole and Single DIN in this one. Cubby hole is really well done, but dont know anything about doing it.

Lee

Title: 2 Single Dins ?????
Post by: iaint on September 02, 2003, 08:41:30 AM

I remember reading in another thread (maybe on FDUK) that Halfords also do a little single din \'pocket\' thing...

Iain

Mazda Rotary Club

General => General Technical => Topic started by: gdhaggis on August 31, 2003, 11:04:52 PM