Basically a mate of mine (idiot) pulled a bit too hard on the handle to try and shut the door, and the handle came off :mad: , its back in its groove but if anyone uses the handle to shut the door it will pop back out any suggestions on how to secure this or do I have to buy a whole door card????
Thanks
Shaq
Take the door card off, and fibre glass the handle back in place. Remember to use LOTS AND LOTS of the stuff.
I am sure that the Bish will post on this.
Dan
When mine broke l managed to sneek a large oversize washer up in the handle to rescrew it , been fine since
Hope this helps
All the best Clive
clive@mazdarotaryclub.com
//www.mazdarotaryclub.com
clive,
how do i get to this screw ?
do i have to take the the window switch out to gain access?
Shaq
Oh ok then.
2 methods -
1)remove the door panel, and from the back get fine glassfibre/polyfibre ribbon, shred it, soak it in resin and let it harden. It\'ll be stronger than the original and it works a treat.
2)Seal the bottom of the door, and pour concrete down the crack between the window and the door. Obviously it\'ll make the door a little heavier, and the window won\'t go down, but it\'ll make sure the passengers don\'t overdo the handle pulling...
OJ
Archbish
Lol !
I was thinking that the second option would be the best for me.
(now where can I get cement from) :p
Thanks
Shaq
OJ will most likely donate some from the large supply between his ears :)
God I am hung over and so not funny
Coats on
Dave
((don\'t worry dave, you\'re as funny as you normally are...))
:D :D :D :rollin