Print Page - anyone no where the temp sender unit is

Title: anyone no where the temp sender unit is
Post by: gavin on August 26, 2003, 07:17:17 PM

temp gauge not working i will need directions as to where it is under the bonnet

Title: anyone no where the temp sender unit is
Post by: tsh on August 28, 2003, 02:39:32 PM

In the block, somewhere near the plugs, I think. There\'s also a knock sensor, and oil pressure sensor around there though...

Sean

Title: anyone no where the temp sender unit is
Post by: 20B_boy on August 28, 2003, 03:05:29 PM

Hmmm...is that right?

Knock sensors are on the rotor housings, yeah, and the oil pressure sender is the lump on the back of the block, right?

But the sensor for the coolant gauge is in the back of the water pump housing on the FD isnt it?? Smack in the front/middle of the engine?

R.

Title: anyone no where the temp sender unit is
Post by: maximtaylor on August 28, 2003, 03:14:34 PM

This is like looking for the g spot......................

Regards

Max

Title: anyone no where the temp sender unit is
Post by: clive on August 28, 2003, 06:09:38 PM

QuoteOriginally posted by maximtaylor
This is like looking for the g spot......................

Regards

Max

Pig of a thing to find , it\'s on the rear Rotor housing / up above and back from the plugs , only visible from the underneath , has one wire on it via a spade connector.

11mm spanner fits it from memory.

Hope this helps.

All the best Clive
clive@mazdarotaryclub.com
//www.mazdarotaryclub.com

Title: anyone no where the temp sender unit is
Post by: gavin on August 28, 2003, 08:24:33 PM

thanks guys will have a look on friday, just been modifying the drive to get the car in/out without ripping a hole in the floor , need to raise the suspension an inch or two :D

hope the spade has fell off nice easy job to fix :rollin

Mazda Rotary Club

General => General Technical => Anything Engine/Performance/Tuning related => Topic started by: gavin on August 26, 2003, 07:17:17 PM