hello
Just fitted my convertor and its not working. Do you use the central white conection block with the yellow/red cable?
Cheers jamie
is the speedo working at all? I have had a few faulty chips recently.
Have you got the wiring diagram, i\'ve got a pretty good self explanatory diagram here i could send over
Yea the speedo was working but it was all over the place even if i was wasnt moving. Had it happen on my evo before said i was doing like 300mph when not moving
Wow!! iv heard they are quite quick :D
Yea it even went up 1500 mph on my apexi avcr
Hello recieved the replacement today and its exactly the same any ideas. Or is it another shaged convertor?
Could it be the crapy ecu that has been put in it. With no speed or rev limits at all?
And the trip is still reading km not mph
Cheers jamie
id take it to someone who deals with them all them time but, vould be anything :(
it\'s a bit of a trek but if you can get over to cranleigh near guildford i\'ll have a look for you, thats where my workshop is
Quote from: MaddenHello recieved the replacement today and its exactly the same any ideas. Or is it another shaged convertor?
Could it be the crapy ecu that has been put in it. With no speed or rev limits at all?
And the trip is still reading km not mph
Cheers jamie
The trip will always say KM but it is miles once it\'s sorted, it won\'t be anything to do with the ECU as all the chip is doing is converting the signal that you must have for your speedo to work.
The speedo does work in KM/ph doesn\'t it?
its fitted right but it seems to keep cutting out. I was doing 70mph down the motor way and i kept on dropping to zero. Im going to take it off again tomorrow and try and get a good live from somewhere and solder all the joints
No the speedo is in mph but the trip seems to be counting up a bit quick like its in KM. Let me get this right its the central white conection block and the yellow and red wire?