Text only | Text with Images

Mazda Rotary Club

General => General Technical => Anything Engine/Performance/Tuning related => Topic started by: Welsh Dan on August 10, 2005, 10:39:33 AM

Title: Mounting additional injectors in the intercooler pipe-how far from throttle body?
Post by: Welsh Dan on August 10, 2005, 10:39:33 AM
As above.

See bottom post for new problem.
Title: Mounting additional injectors in the intercooler pipe - where can I get holders from?
Post by: Fish on August 10, 2005, 10:50:49 AM
I think Greddy make an elbow that has this already built on.

Fish
Title: Mounting additional injectors in the intercooler pipe - where can I get holders from?
Post by: Welsh Dan on August 10, 2005, 11:02:04 AM
See bottom message
Title: Mounting additional injectors in the intercooler pipe - where can I get holders from?
Post by: Fish on August 10, 2005, 12:08:52 PM
Ah the joys of owning an FD. THINGS ARE NOT CHEAP!

Fish
Title: Mounting additional injectors in the intercooler pipe - where can I get holders from?
Post by: Welsh Dan on August 10, 2005, 12:11:43 PM
See below.
Title: Mounting additional injectors in the intercooler pipe - where can I get holders from?
Post by: Welsh Dan on August 13, 2005, 12:51:43 AM
Righto, i\'ve managed to find a pair of flanges, which came to the bargain price of £35, + shipping.

However, i\'m a bit worried now about mounting the injectors quite far away from the throttle body. Before the plastic elbow is a bit of samco piping, so it has to be somewhere between there and the light.

Am I ok to mount the pair of injectors by the passenger side light (by the air con thingy?) or is it worth buying a greddy elbow and getting some custom piping made up from there so that I can mount them a bit closer? I\'m not keen on spending the extra money, but would rather that it is done properly the first time. I\'ve been made aware that it could cause droplet formation if they are quite far away?
Text only | Text with Images