...with routing a water pipe from a WI kit along the underside of the car? Having it tucked up in the skirt maybe.
Its just i\'ve found a nice little hole in the rear seat recess that would make installation a bit easier
As long as its away from the following:-
Heat source
Friction
Snagging risks
then I can\'t see a problem with it, might be worth while buying some conduit to run it through for extra piece of mind. :)
yeah that sounds like a good idea, looks ok under there but i\'ll give it a good once over to make sure.
Also got some electric wire to run but I take it thats best kept in the car, any ideas of the best place to poke it through, I cant seem to find anywhere, bit where the ecu wires go through look promising but is proving to be a bit troublesome :)
If you don\'t mind pulling off panels inside the car then you can normally find an abundance of holes/gulleys and unused grommets! :)
time to get pulling then :)
Maybe it would freeze in the winter if parked up outside for awhile,
unless you have aditives in it :yes
Paul..
Dont worry they\'ll be plenty of additives in there ;)
Ooh, i don\'t like e-numbers! ;)
Will there be a problem with additives!!!! giving off fumes in the car?
hmmm, not sure actually...! they will be diluted and the bit where the tank will sit is being boxed off, but it is deffo worth thinking about!
Just make sure you have a decent o ring seal on everything and you should be ok.