Print Page - Custom Gauge Holder

Title: Custom Gauge Holder
Post by: grinder on April 13, 2005, 10:33:33 AM

Im in the process of making a custom gauge holder that will slot in above the radio

it will hold 3 gauges

i will take pics as i go along and post them on here

i know you can buy these from the states for about $60 but thats not the point - mine is free :)

Ta

Stu

( bloody typical - the pics didnt copy to my pen drive :( - will get pics up tomorrow )

Title: Custom Gauge Holder
Post by: grinder on April 13, 2005, 02:13:23 PM

the gauges will be

1 - boost
2 - A/F gauge
3 - Not sure - depends if GMAN cracks and sells me a water temp gauge

2 for defo - but will do a 3 gauge holder

its just looking a bit naff at this moment intime ( althought the better half said it looked OK ! )

pics tomorrow ( if the pen drive likes me ! )

Stu

Title: Custom Gauge Holder
Post by: grinder on April 14, 2005, 09:57:56 AM

Title: Custom Gauge Holder
Post by: grinder on April 14, 2005, 09:58:41 AM

Title: Custom Gauge Holder
Post by: grinder on April 14, 2005, 09:59:01 AM

Title: Custom Gauge Holder
Post by: grinder on April 14, 2005, 09:59:17 AM

Title: Custom Gauge Holder
Post by: grinder on April 14, 2005, 09:59:44 AM

Title: Custom Gauge Holder
Post by: grinder on April 14, 2005, 09:59:58 AM

Title: Custom Gauge Holder
Post by: grinder on April 14, 2005, 10:00:11 AM

Title: Custom Gauge Holder
Post by: grinder on April 14, 2005, 10:00:25 AM

Title: Custom Gauge Holder
Post by: grinder on April 14, 2005, 10:00:42 AM

Title: Custom Gauge Holder
Post by: grinder on April 17, 2005, 07:58:20 PM

im now onto the 2nd attempt - didnt like that one

major prob is the 52mm hole to cut - need to do it with a hole saw to make it need

Title: Custom Gauge Holder
Post by: grinder on May 12, 2005, 02:16:25 PM

well after a rethink and getting my dad on the case we did a new holder that looks a lot better

and here it is fitted in the car :

Title: Custom Gauge Holder
Post by: jetpilot on May 12, 2005, 04:14:09 PM

Snap

Title: Custom Gauge Holder
Post by: TRex on May 12, 2005, 11:17:58 PM

Not one to be left out... :D

Title: Custom Gauge Holder
Post by: grinder on May 22, 2005, 12:48:01 PM

***** THREAD CLEANED AND LOCKED *****

Thanks

Stu / Grinder
MRC Moderator Team

Mazda Rotary Club

Cars by Model Type => 2nd generation RX-7's => Topic started by: grinder on April 13, 2005, 10:33:33 AM