HI all
I\'ve got a set of english instructions for this but cant make out if I connect the wires to the connector or splice into the wires??
& is this the right part of the loom, its below the elbow from the plenum & between the w/arch & the engine
You can get a proper plug in harness for these to save any cutting or splicing.If your gonna go the splicing route then yes it is the right plug and you splice in as per colour codes on the instructions.Very important that you get them right mate.
cheers thought there must be a specfic harness, think I\'ll go that route as its hard enough to get to the plug let alone splice into it.
ta
gerry
Remove the piece of loom between the 4 pin connector and the coils, then you can work on the loom on a bench. it is not difficault. If you need to know the colours let me know and I will write them up.
Removing the loom is easy with Upper Inlet Manifold off,if you haven\'t got that removed then i wouldn\'t attempt removing the loom,it is a mission.Also splicing Twin Power in,will cause problems later if you wish to remove it,by using the plug in loom its simple to fit and remove,no hacked coil loom where you have tried to cut it out,just means a few days of waiting.
how did u do this after,did you buy the harness?
if so where did u get it from :D
I got the harness but only this month its been lying in the shop for ages, I got RXaberdeen on here to get one for me thru his work was about £30,
Hey you got a pic of it installed?, was thinking of buying one
Not yet as its not installed as I only got back to dry land yesterday
part number for the loom harness is 4399-SZ001, I\'ll get some pics up soon as I installed it today