Guys, Im thinking of fitting harness\' instead of existing inertia reel belts. Any reccomendations? Three point will I think be enough., although open to suggestions!
Any advise gratefully recieved, oh, and of course pointers as to where I can get \'em from!!
Ian
Ok, I\'ve done this:
First off, get a harness bar from
http://www.rotaryextreme.com/
I paid $325 last August.
This acts as a rear strut brace, but is beefed up and has 4 eyebolt holes for driver and passenger side harnesses.
Then buy a 4 or 5 point harness from demon tweeks. These come with the eyebolts usually, but make sure.
Make sure your seat has the holes for the shoulder straps :)
The shoulder straps are at a near perfect horizontal angle doing it this way.
Mount the lower harness straps on the existing seat belt mount points.
If you\'ve gone kinky and bought the 5 point ball cruncher strap, you\'ll need to drill a hole in the floor under the seat, and adequately plate to ensure the strength is there. Make sure (again!!) that your seat has a hole for the 5th strap.
I have retained the existing belts as well, to keep it road legal.
Cheers me Ole mucka!
Back from yer travels then?? :)
Ian
Back home from the Maldives, off to Nurburgring in a week :)
Life is sooo hard, being a man of leisure ;)
My new middle name is \'b@st@rd\'
LOL!!!
Well Im at home with a buggered KNee after a little skiing trouble!!
Oh dear :(
Pop down Saturday would you, so I can take the **** a little ;)
I\'m finally putting my Feed bush kit in!
Or rather, Chris is, I\'ll be making the cups of tea ;)
Well 1st thing there bud is Im not sure I can drive, second and much more importantly its the Calcutta cup!!!
Thanks for the invite though! :) Sorry to take away one of life\'s small pleasures.....ie taking the pi$$! :)
One other thing dude, SHould have asked before. What seats you usung?? Im still stock and dont really want to go to the expense of changing them at the moment.
Ian