OK. i want to cheak the timing but my light is going banana\'s
i put the ht lead conector on the leading 1 lead and the rpm reading on tick over was about 5000rpm. obviously not firing once every two turns of the crank.
the timing marks weren\'t anywere near either. i have read that certen types of light should be conected on the trailing coil lead. this was better but still well off.
so how is it supposed to be done :confused: :confused:
well ??:confused:
ok i did it.
...and how was it?
John
Probably the best set up t2 in the country