Rotary go kart

[clive]

Great that this is coming along. (love the mudguards)
You obviously have experiance from the other car, but seeing the tank, if its not foam filled you will need a swirl pot and then as Jon says just a Walbro 255 pump 

[baloo]

Yes you can it unclips and you can extend the pick up. Theres a syphon part you can junk. I did similiar in my alloy tank in my westfield.

Sent from my SM-N950F using Tapatalk

i will remove the pump from the tank and have a looksy,    might have to make a tool to undo that big ring thought  it seemed very tight

[boosted]

Big masonary screwdriver...hit with a hammer.

Sent from my SM-N950F using Tapatalk

[baloo]

Yes you can it unclips and you can extend the pick up. Theres a syphon part you can junk. I did similiar in my alloy tank in my westfield.

Sent from my SM-N950F using Tapatalk

did you use an RX8 pump in an alloy tank ?   if so how did you hold it in ?

[boosted]

You tank the hole fuel pot out so internal reg and filter remain..that can be seperated to allow suction on bottom tank by lengthing with piece of alloy or suchlike. Electrical wires lenthen and pipe to outlet .
Tricky bit is cutting whole and welding on studs and making a gasket. Holes can be drilled for said studs on outside rim of fuel pot.

Sent from my SM-N950F using Tapatalk

[baloo]

You tank the hole fuel pot out so internal reg and filter remain..that can be seperated to allow suction on bottom tank by lengthing with piece of alloy or suchlike. Electrical wires lenthen and pipe to outlet .
Tricky bit is cutting whole and welding on studs and making a gasket. Holes can be drilled for said studs on outside rim of fuel pot.

Sent from my SM-N950F using Tapatalk

so you drilled new holes in the top flange of the pump and bolted it to tank ?  thats what i was wondering about or whether i had to use the screw down collar which would mean i had to make  up a new screw thread to weld onto tank 

[boosted]

Yes..pita but once done. Made a seal out of ptfe.

Sent from my SM-N950F using Tapatalk

[Mr Spiller]

These are cheap


Sent from my iPhone using Tapatalk

[boosted]

Ive had multiple sets of team dynamics. Good lightweight wheels! I had a nice set on my silver rx8 s type.

Sent from my SM-N950F using Tapatalk

[Mr Spiller]

Ive had multiple sets of team dynamics. Good lightweight wheels! I had a nice set on my silver rx8 s type.

Sent from my SM-N950F using Tapatalk

Yep
BTCC wheels
If they were 18 I’d have have


Sent from my iPhone using Tapatalk

[baloo]

thank you for that   they would be ok for the fronts   would like wider for the rear    im on the trail of some 

[baloo]

ok so whats all this about  ?  ive got the brake pedal assembly out and there is a cable fitted to the top with a proper nipple but the steel cable only goes down and round the pivot of the pedal   whats it for den ?

[baloo]

started folding up the pedal box   seemed to be going good for a while   

[baloo]

[baloo]

made a bit of an error there but  the man who dident make a mistake never made anything i seem to remember being told  lol