« previous next »
Pages: [1]   Go Down

Author Topic: Front pulley  (Read 450 times)

Offline mercomms

  • MRC Full Club Member
  • Newbie
  • *****
  • Posts: 4
  • Karma: +0/-0
  • Just joined!
    • Manchester
    • View Profile
Front pulley
« on: April 12, 2020, 05:22:00 PM »
Hi guys, this may seem like a silly question. "Is the front pulley bolt right or left hand thread". I`m asking because I`m stripping down my engine and I cannot get the bolt to move either way. I`ve got my flywheel lock on and just want to be sure of the thread before I get my 3/4 drive power bar on it ha ha.
Thanks
Dave
Logged

Offline clive

  • MRC Founder
  • Administrator
  • Major Contributor
  • *****
  • Location: Kent
  • Posts: 11,528
  • Karma: +31/-0
    • View Profile
    • http://mazdarotaryparts.com
Re: Front pulley
« Reply #1 on: April 12, 2020, 05:27:36 PM »
Right hand thread and these bolts offen bite real tight, so yes 3/4 drive bar  and a nice hexagonal 19mm socket  required
Logged
All the best Clive

Offline mercomms

  • MRC Full Club Member
  • Newbie
  • *****
  • Posts: 4
  • Karma: +0/-0
  • Just joined!
    • Manchester
    • View Profile
Re: Front pulley
« Reply #2 on: April 12, 2020, 06:07:43 PM »
Nice one Clive, thanks very much.  :13:

Dave
Logged

Offline Grant Monkhouse

  • Karma Chameleon
  • Global Moderator
  • Major Contributor
  • *****
  • Posts: 4,936
  • Karma: +1/-65535
  • I am awesome
    • View Profile
Re: Front pulley
« Reply #3 on: May 18, 2020, 06:01:18 PM »
Any specific flywheel lock needed to get the front pulley nut off? And alternatively for tightening the flywheel nit on also.

Thanks

Sent from my VOG-L09 using Tapatalk

Logged
Pages: [1]   Go Up
« previous next »