Author Topic: Westfield se rx8 231 streetport for sale. Race hillclimber track. road legal.  (Read 1072 times)

Offline boosted

  • MRC Full Club Member
  • Major Contributor
  • *****
  • Location: Westbury Wiltshire
  • Posts: 9,165
  • Karma: +25/-1
  • Worryless, Dream more.
    • south west
    • View Profile
Got storage so that means fd can go in garage at least....£8k take it away

Sent from my SM-N950F using Tapatalk

92 FD rx7 Twins 13.5psi. Track car
94 Westfield Se 231 rx8 street port powered. Race car
EAT SLEEP ROTOR REPEAT.

Offline Jamie R

  • MRC Full Club Member
  • Major Contributor
  • *****
  • Posts: 1,680
  • Karma: +2/-0
  • Getting older, fatter, wiser!
    • Worcestershire
    • View Profile
I appreciate the discount.....

Wish I had the cash spare....

its all going on the rotus atmo.

Sick of sanding, prefer doing it outside but the nights are drawing in....

I did change that over load switch on the compressor today. Got confused coz the original switch had 1 and 2 on the spade terminals, and on the new one it had line and load.

well theres a 50 50 chance ill get it the right way round.

It aint gone bang yet, and hasnt cut out.

Winner winner chicken dinner
Its just Rotors and GRP

Offline boosted

  • MRC Full Club Member
  • Major Contributor
  • *****
  • Location: Westbury Wiltshire
  • Posts: 9,165
  • Karma: +25/-1
  • Worryless, Dream more.
    • south west
    • View Profile
1 line 2 load..
Load after line 2 after 1.


Sent from my SM-N950F using Tapatalk

92 FD rx7 Twins 13.5psi. Track car
94 Westfield Se 231 rx8 street port powered. Race car
EAT SLEEP ROTOR REPEAT.

Offline Jamie R

  • MRC Full Club Member
  • Major Contributor
  • *****
  • Posts: 1,680
  • Karma: +2/-0
  • Getting older, fatter, wiser!
    • Worcestershire
    • View Profile
Ill be honest i took pot luck, I should have at least even noted which wires went where.

Theres a red bull can sized thingy inside next to the switch.... is that a capacitor or something ? stored energy for initial inrush start up.... something like that from uni rings a bell...

The one wire to the switch looked a bit brittle on the insulation, I bet that was from when i put a piece of gaffer tape over the over load switch stop it popping out lolllll

This rotus is gonna have an electrical fire i swear hahaha
Its just Rotors and GRP

Offline boosted

  • MRC Full Club Member
  • Major Contributor
  • *****
  • Location: Westbury Wiltshire
  • Posts: 9,165
  • Karma: +25/-1
  • Worryless, Dream more.
    • south west
    • View Profile
Bump still for sale...

Sent from my SM-N950F using Tapatalk

92 FD rx7 Twins 13.5psi. Track car
94 Westfield Se 231 rx8 street port powered. Race car
EAT SLEEP ROTOR REPEAT.