The car started fine, ran out of fuel outside the house(was stood for a while) then after lots of attempts to start, burned the starter motor.
So changed for a new starter motor, she started up straight away and would only idle, any gas and would cut out.
Now she not starting at all. At first it tried to start, now it just doesn't even attempt too.
I've done the following;
1) Cleaned plugs. They kept getting soaking wet of fuel after cranking so changed injectors to standard rails (were aftermarket before). Now seem to be normal with little fuel but still no attempt to start.
2) Checked injector wiring (lightbulb test) and operating ok.
3) Fuel pressure when cranking is 42psi
4) Have spark.
5) No fuel leaks.
6) cant see any boost leaks (very few vacuum lines as single turbo)
7)Not done compression check, but when plugs out have even, loud swoosh noises.
When cranking PFC shows 8 & 0 degrees for IGN.
I've also noticed that when cranking over,in the PFC Sensor screen the PIM, VTA 1, VTA2 highlight and voltage shows 0.00V. This is only when cranking, when the key is just in the on position they are not highlighted and show correct voltage. Is this normal?
Anyone have any ides what to try next?