Author Topic: Flange sealant question.  (Read 257 times)

Offline boosted

  • MRC Full Club Member
  • Major Contributor
  • *****
  • Location: Westbury Wiltshire
  • Posts: 10,343
  • Karma: +25/-1
  • Worryless, Dream more.
    • View Profile
Flange sealant question.
« on: August 13, 2015, 03:50:51 PM »
my new alloy sump is leaking...from alloy to cast joint.

I used clear 250 degC rtv silcone on alloy to cast bottom of rx8 engine....but after heat cycle its weeping in a few places. I used this several times with standard sump spot on but does not appear to be up to the job with the alloy sump.

Searched for sump sealant here there and everywhere but not sure what i need.....i even went to VW but they want £21 for a long half filled tube that will do half a sump.....( there sumps are alloy and strip there drain plugs threads lol).

any personal recommendations ?
92 FD rx7 Twins 13.5psi.  EX Track car

Offline Alexsavv

  • Newbie
  • *
  • Posts: 66
  • Karma: +10/-0
    • View Profile
Re: Flange sealant question.
« Reply #1 on: August 15, 2015, 11:04:35 AM »
Try and stud your sump onto the engine, would give a tighter hold